To remove the front cover, open the dryer door and take out the lint filter/trap. Once disconnected, place the control panel out of the way and put the screws in a safe place. Be careful not to pull it off completely as you’ll need to disconnect the wire harnesses that connect the panel to the dryer before it can be removed. This can be done by unthreading the screws that hold it in place and then it should clip off. The next step is to remove the control panel from your dryer. Once removed, put it out of the way and keep the screws in a safe place.
To remove the cover, unthread the screws that hold it in place and the panel should clip off. This is because the heating element is behind it. Once the dyer has been disconnected from the vent and power supply the next step is to remove the back cover. Next, switch the power off by unplugging your dryer. If your dryer has an exhaust hose attached to it, disconnect it. Start by pulling your dryer out from the wall or, if it is attached to the wall, take it down so you can gain access to the heating element. This guide covers all major Samsung dryer models, including:ĭV48H7400EW/A2-0000 Step 1 – Disconnect your dryer Just make sure you order the correct replacement part from your hardware store or online retailer. All you’ll need is a screwdriver and a replacement element and you should be fine.
#Samsung dryer heating element repair cost install
Simply follow the steps in this guide to remove the old element and install the new one and you’ll have your dryer back operating in no time. But don’t stress, replacing the heating element in your Samsung dryer is easy to do and doesn’t take too long. When this happens, it will need to be replaced. If your Samsung dryer has stopped heating or is not heating properly, a faulty heating element is the most likely cause.
0 kommentar(er)
